The Arlo camera is a Wire-Free, completely wireless, HD smart home security camera. The Arlo camera is weather-resistant and it also contains motion detection, night vision

How do I set up and sync my Arlo Pro or Pro 2 Wire-Free cameras?

Here we discuss about Arlo Pro or Pro 2 Wire-Fire cameras. These directions apply to setting up Arlo Pro 2 or Arlo Pro cameras with Arlo Pro 2 base stations, Arlo Pro base stations, and Arlo base stations. If you sync Arlo Pro 2 or Arlo Pro cameras with an Arlo base station.

Note: Cameras must be synced one at a time.

To set up and sync Arlo Pro 2 or Arlo Pro cameras:

1. Firstly, open the battery compartment by pressing the latch and pulling back gently.
2. Then, Insert the battery as shown and close the battery door.
3. After this, conduct the camera within one to three feet (30 to 100 centimetres) of the base station.
4. Sync the camera to the base station:
5. Press the Sync button on the side of the base station just for 2 seconds and then release the button. If you are using an Arlo base station
6. Note: If you press down the Sync button on the Arlo base station for long time.
7. The LED under the USB symbol blinks amber for 10 minutes. While the USB LED is blinking amber, the sync process is blocked. If you are using an Arlo Pro or Arlo Pro 2 base station, press the button on the top of the base station for about two seconds and then release the button.
8. Hold up for the sync status LED to flicker green.
9. After that, press the Sync button on top of the camera for around about 2 seconds and then release the button.
10. A blue LED on the camera blinks rapidly to confirm sync.
11. If the LED on the camera blinks amber, the sync is not successful. You should repeat the sync process.
12. Additionally, check the camera LED on the base station.
13. The sync process is complete. If the camera LED on the base station turns solid green.
14. Moreover, repeat these steps for each camera.

Note: If you do not finished the sync process in between 60 seconds, and press the button on the top of the base station and attempt it again.